Winter 2020 Sponsorship Drive – last chance for gpma.org caps

Posted on by
Get your official GPMA cap while they last:
 
gpma.org cap
 
Free with your donation. Just let me know you want one, and I’ll send it out to you.
 
Member Donations

Click this button to make a $25 donation now using PayPal.

To donate by check or money order, make your check payable to Kevin Stewart and mail to this address:

Kevin Stewart
4400 Keller Ave #387
Oakland, CA 94605
USA

 

Porsche 991 RSR

Posted on by
991_RSR_LFU
By William Bauer (for JayKay)
Details
Body: Scale Auto Slotcar
Chassis and Interior: Fujimi 997 R
Dash and Stearing wheel: Scale Auto
Decals: Slotfabrik
Wheels: Hobby Design
Tires: Scale Production
Build
First things first. There is no kit of this car.  You are going to use plenty of things to do this.  You must find and use your own reference materials
991_RSR_LF
Body: expand the wheel openings to fit the Fujimi tires, even though they will not be used.
Remove all the slotcar screw points and fill any holes. Separate window glass. Open front NACA duct and seal all of the fuel filler ports on the hood.  Extend the front of the dash by approx 1/4″. Close the rear wing positioning holes.
Chassis: Lengthen approx 1/4” in the Center to match the wheel wells. Remove approximately 3/4″ of the rear(engine) section.  Remove the front of the chassis in front of the wheel wells.
IMG_0612
Interior: Build the Fujimi interior as stock, but use the Scale Auto dash and steering wheel.
Wing:  I used the Scale Auto wing, but technically, it is too small. Use a Fujimi Porsche kit wing or a Fujimi BMW Z4 wing.
Wheels: Hobby Design 19″GT3 are best, but may be difficult to find now. Do not use the Fujimi kit wheels.
Tires: The Fujimi kit’s tires will make the car look like a 60’s muscle car.  Scale Production makes a decent 19″ front and rear set.
991_RSR_RT
Decals: These are Slotfabrik out of Germany. Notfor this body so U need to message them. They are also thick, so plenty of “melt your decal” needed. They are all on one sheet with no nice demarcation lines.  You will need to cut them close youself. No placement directions either.
991_RSR_RRS
Notes
Time:  It takes way too long, but you’ll need it to cut and fit, cut more and fit. I used expoxy on this kit exclusively. You need those extra minutes to set things up.
Libations:  way too much, but you’ll need it. Not for the faint of heart, and keep working with it. Remember, the body was designed for quick assembly. Slow down and use real glue.